Introduction of anti-static rubber sheet
The scope of application for anti-static rubber sheet. The production workshops and advanced laboratories of the microelectronics industry, such as electronic semiconductor devices, electronic computers, electronic communication equipment and integrated circuits. They are mainly used for laying table tops, assembly line counters, shelves and floor mats, and are suitable for different conditions and different environments.
Features: releasing the static electricity of the human body, to achieve a uniform potential between the human body and the ESD tweezers, tools, instruments, meters, etc. Making the electrostatic sensitive device (SSD) do not interfered by the electrostatic discharge phenomenon, thereby achieving the effect of static electricity protection and avoiding damage to the device. This product does not contain harmful substances such as S, Hg, NH3+, Pb and so on. Softness: soft, strong rebound and toughness. Whether it is used in the cold north or in the warm south, it maintains its softness and flatness.
Anti-static rubber sheet product introduction. The product is generally two-layer structure, the surface layer is a static dissipative layer, and the bottom layer is a conductive layer. Gold collar anti-static mat has long-lasting use, good acid, alkali and chemical resistance, and is wear-resistant and easy to clean.
Pressure-resistant method of insulating rubber sheet
Test method for withstand voltage performance of insulating rubber sheet: Each insulation rubber sheet is required to withstand voltage performance test. The inspection method is to place the insulating rubber sheet on the frame with the metal plate (usually available aluminum plate), put a metal plate which is 10cm smaller than the insulation board on the insulating rubber plate, then place an electrode connected to the transformer on the metal plate. The other electrode is connected to the other side of the insulating rubber sheet, Rising to the specified voltage at a speed of about 1000V/s, continuing for 1 min and record the reading indicated on the mA meter. Non-piercing is a qualified product.