Installation method of antistatic rubber plate

Installation method of antistatic rubber sheet: Firstly, check the condition of the ground before laying the rubber sheet. If the floor is a smooth concrete floor, terrazzo, tile or wooden floor, you can directly lay the rubber sheet. At the same time, we must ensure that the ground is neat and clean, there is no unevenness, and there must not be many small uneven pits. The point that cannot be ignored is that the ground must have sufficient strength, no sand and no shelling, and keep the ground dry. These are the prerequisites for laying antistatic rubber sheets.

Next, clean the ground with a cleaning solution and cleaning agent, and then lay the ground grid. Use copper bars with a thickness of 0.25 mm and a width of 2.5 cm. The interval between the copper bars and the number of copper bars can be determined according to the width of the ground. Generally, a copper bar is used every two or three meters apart. It should be noted that when placing the copper bar, one end of the copper bar should be connected to the ground.

Finally, after the grounding conductive mesh is laid, laying the antistatic rubber sheet on the ground in the correct way. If the bottom gap is large, you can use a knife to trim it to make the gap as small as possible. Then apply the glue to the place with small gaps, leave it for about twenty minutes, and allow the glue to air dry. After all the laying is completed, roll it with a heavy shaft several times, and it can be used normally after standing at room temperature for 2 days.